Urban Heater tubular heater 300W

The tubular heater without thermostatUrban Heater 300Wis mainlydesigned for growers and breeders of smaller animals.
The heater is suitable for growing in greenhouses, growboxes and other growing spaces.

You will use it especiallywhen caring for seedlings andcuttingsin the winter and colder months.

For perfect control of the growing space, it is ideal to combine the UrbanHeaterwith a thermostat.KT3100or theCLI-MATE Thermostat 16A temperature controller.

Main advantages:
- maintains a constant temperature
- requires almost no maintenance
- supplied with brackets for wall or floor installation
- safety fuse against overheating
- low power consumption
- high protection IP55

Technical specifications:
- Power: 300W
- Length: 1520 mm
- Protection: IP55
- 220-240V, 50 Hz

When and why to use the heater whenindoorsindoor growing?
Caution, it is impossible to say how long and how many degrees you will heat the growing space. The manufacturer does not provide this information. This is because the resulting temperature is influenced not only by the power input of the heater itself, but also by the initial temperature and especially by the size of the space. The ambient temperature and how well the indoor space is insulated also have an influence.

If the initial temperature inside the grow box100x100x200 cm(2 m3 space) is for example 10°C and you want to raise it to 20°C, this will take some time depending on the conditions. If you want to heat thegrowbox200x200x200 cm(space 8 m3) from 10° C to 20° C, it will take about 4 times longer with the same power. With lower wattage heating you probably won't be able to do it at all.

Moreover, when growing, it is not necessary to heat the whole space constantly at maximum.

The most important thing is a constant temperature around the plants themselves. That's why heaters are mainly used to maintain a stable temperature.

What never to do with an Urban Heater:
- do not turn on until it is perfectly installed
- use out of reach of children and pets
- do not tamper with if the heater is plugged in
- do not immerse in water
- do not leave the cord draped over the heater
- do not install the heater near flammable or combustible objects
- unless it is in use, unplug it from the mains
- only use a clean cloth to clean it
- for further instructions, please refer to the instructions included in the downloads