Socket thermostat with time switch and external sensor KT3100

The KT3100 drawer thermostat with time switch is a combination of a drawer thermostat and a time switch.
The timer can be set for cyclic operation or for one-time on/off or one-time on/off with delay. Operation is possible without the use of a timer.

If the temperature condition is not fulfilled and the timer has run out, the contact will open.
If the temperature condition is fulfilled and the timer has not yet run out, the contact will also open.

The simultaneous function of the timer and the thermostat is not functional!

Specifications:
- power supply100-250VAC 50Hz
- load 16A (3680W)
- consumption at rest 0,01mA
- consumption when relay is closed 0,02mA
- thermostat temperature range: -40°C~120°C
- accuracy ±1°C
- resolution: 0,1°C
- time resolution: 1minute
- maximum adjustable time: 99hr 59min
- maximum deviation: 10minutes / 100hr
- inverse operation option - heating or cooling mode
- external temperature sensor with 1.8m cable

Setting modes:
The setting modes can be activated sequentially with the MODE button:
1. Thermostat mode without time programming:
The SET and then DOWN and UP buttons can be used to set the temperature for switching on and off, with a resolution of 1°C below -10°C and 1°C above 100°C.
2: F01 Cycling on/off mode:
The thermostat on/off time can be set. Time periods are set, not real times. The switching on and off is cyclical.
3: F02 Delayed switch-on mode:
The switch-on delay can be set in the interval 1min-99hr 59min.
4F03 Delayed Off Mode:
The off delay can be set in the interval of 1min-99hr 59min.
5: F04 Single On/Off Mode:
The times after which the thermostat should be turned on and off can be set. The thermostat will remain at the default setting after the cycle has expired.

Instructions for use:
1) Insert the thermostat into the socket. The thermostat is now in the no time programming mode and the display shows the actual temperature and the set on and off temperatures (preset ON 20°C and OFF 25°C). A short press of the SET button can be used to enter the ON and OFF temperature adjustment mode. These can be changed using the UP and DOWN buttons. If the ON temperature setting is lower than OFF, the sun symbol flashes above the real temperature reading and the thermostat is in heating mode. Otherwise, the thermostat is in cooling mode and a snowflake flashes on the display. When the setting is complete, confirm by briefly pressing the MODE button. A long press of the SET button (5s) can change °C to °F.
2) A short press of the MODE button can activate the time switch with modes F01, F02, F03 and F04 (described above). The SET, UP and DOWN buttons can be used to set the on and off times.
3) By long pressing the MODE button (2s) in the respective mode F01-F04, the timer function can be activated. Then the display will flash ON or OFF depending on the time period the thermostat is currently in. The switched state is also indicated by a blue LED.
4) The thermostat function is retained even in timer mode.