Fan TT 125 U, 280 m3/hr

APPLICATION:
The Vents TT 125 U fully meets the requirements for high pressure yet low noise. The fan finds its application in areas with very high humidity such as greenhouses, nurseries, cellars, public toilets, factory kitchens, archives, etc. Thanks to its technical parameters, it is designed for extraction in ductwork up to 17 metres. This fan with electronic temperature sensor and controller is used for automatic speed control depending on the air temperature in the ventilation duct or inside the room.

MOTOR:
The single phase ball bearing motor has two speeds that can be switched by an external switch. The motor is equipped with a thermal fuse with automatic restart. IPX4 degree of protection.

TERMOSTAT: if the temperature rises 2 °C above the thermostat setting, the fan automatically switches to a higher speed. When the set temperature is reached, the fan switches back to a lower speed and continues to extract.

INSTALLATION:
The fan can be installed at any point in the duct system - horizontally. In addition, several fans can be installed simultaneously to increase the pressure or capacity of the transported air. The fan body is equipped with a mounting plate for wall mounting.

The fan is supplied with a supply cable.

Technical parameters:
- diameter: 125 mm
- air flow: approx. 100-280^m3/h
- ball bearings: yes
- max temperature: 60 °C
- speed: 1060/2500 per min
- static pressure: 105/138 Pa
- sound pressure: 29/36 dB/1m
- power supply: 230V 50Hz
- power input: 23/37 W
- rated current: 0.19/0.26 A
- protection: X4 IP
- weight: 1.40 kg

Here you can find the datasheet.