Fan TT 150 U, 552 m3/hr

USES:
The Vents TT 150 U fully meets the demands for high pressure yet low noise. The fan finds its application in areas with very high humidity such as greenhouses, nurseries, cellars, public toilets, factory kitchens, archives, etc. Thanks to its technical parameters, it is designed for extraction in ductwork up to 29 metres. This fan with electronic temperature sensor and controller is used for automatic speed control depending on the air temperature in the ventilation duct or inside the room.

MOTOR:
The single phase ball bearing motor has two speeds that can be switched by an external switch. The motor is equipped with a thermal fuse with automatic restart. IPX4 degree of protection.

TERMOSTAT:
If the temperature rises 2 °C above the thermostat setting, the fan automatically switches to a higher speed. When the set temperature is reached, the fan switches back to a lower speed and continues to extract.

INSTALLATION:
The fan can be installed at any point in the duct system - horizontally. In addition, several fans can be installed simultaneously to increase the pressure or capacity of the transported air. The fan body is equipped with a mounting plate for wall mounting.

Technical parameters:
- diameter: 150 mm
- air flow: approx. 200-552^m3/h
- ball bearings: yes
- max temperature: 60 °C
- speed: 2450/2500 rpm
- static pressure: 208/281 Pa
- acoustic pressure: 33/44 dB/1m
- power supply: 230/50 V/Hz
- power input: 30/60 W
- rated current: 0.17/0.27 A
- protection: X4 IP
- weight: 3 kg
- lifetime: 40,000 hours

Here you can find the datasheet.